THEORY: Theory #1: In theory a spirit/ghost may give off a magnetic field, an electric field, and/or a radio/microwave field that can be picked up by a Tri Field Meter. A spirit/ghost may also try to use these fields to manifest.

Theory #2: When a spirit/ghost manifests it needs energy to do so. In an area where there is a high EMF field, the spirit/ghost may draw in that high EMF and manifest.

HOW TO USE: Set the meter to either Magnetic (0 – 100), Electric, or Radio/Microwave. Majority of the times we will use the setting Magnetic (0 – 100). In the field you want to walk around, away from other people, and look for any type of readings. While you’re walking around, check for any type of power lines or power outlets around the area because it can effect your readings. If you get a reading, stop and try to locate the source.

RANGE: Magnetic (0 –100): The range on the meter at this setting is 0mg – 100mg. The range from the meter to the active field is from 0 – 8 feet.

Electric: The range on the meter at this setting is 1volt – 100volts. The range from the meter to the active field is from 0 – 10 feet.

Radio/Microwave: The range on the meter at this setting is 0.01mW/cm2 – 1mW/cm2. The range from the meter to the active field is from 0 – 15 feet.

READINGS: Magnetic: The unit of measure for this setting is milligaus (mg). Paranormal activity occurs between 3mg – 8mg.

Electric: The unit of measure for this setting is voltage. Paranormal activity occurs between 3volts – 8volts.

Radio/Microwave: The unit of measure for this setting is microwaves divided by centimeters squared (mW/cm2). Paranormal activity occurs between 0.1mW/cm2 – 0.3mW/cm2.

Also paranormal activity may cause erratic movement through the needle in any given setting.


Return To Previous Page